Transfer Case Control Module: Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
If a new component is to be installed, connect the Jaguar Land Rover approved diagnostic equipment prior to removal, the adaptive parameter data must then be downloaded. This data will be lost during removal and is required for component configuration on installation.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some illustrations may show the transfer case removed for clarity.
-
CAUTION:
- If replacing the transfer case control module, this step must be completed.
- Once this step has been completed, make sure the Jaguar Land Rover approved diagnostic equipment remains connected to the vehicle.
- Connect the Jaguar Land Rover approved diagnostic equipment.
General Equipment: Jaguar Land Rover approved diagnostic equipment
- Clear any Diagnostic Trouble Codes (DTCs).
- Start the diagnostic service function 'transfer case-transfer case replacement'.
- Follow the instructions on the Jaguar Land Rover approved diagnostic equipment.
- Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Raise and support the vehicle on a suitable 2 post ramp.
Refer to: LIFTING
- Remove the air deflector.
Refer to: ENGINE UNDERSHIELD
- Remove the 3 retaining bolts.
- Remove the exhaust sensor cover.
- Disconnect the wiring harness retaining clip.
- Remove the 2 retaining bolts.
- Position the exhaust sensor and wiring harness away from the transfer case.
- Using a suitable transmission jack, support the transmission.
General Equipment: Transmission jack
Remove the transfer case bush mounting retaining bolt.
- Remove the 6 retaining bolts.
- Remove the transmission support bracket.
Disconnect the transfer case control module connector.
Disconnect the transfer case control module connector.
- Remove the 3 retaining bolts.
- Remove the transfer case control module.