Transfer Case Fluid Level Check: Adjustment
WARNING: This page is about a different variant/trim than selected.
- Top-up the transfer case with recommended fluid, until the fluid is level with the bottom of each of the filler/level plug holes.
- CAUTION: Make sure that a new sealing washer is installed.NOTE: Make sure that all the component mating faces are clean.
Renew Part: Transfer case drain plug washer Quantity: 1 .
Torque : 8 Nm
-
NOTE: Make sure that all the component mating faces are clean.
Torque : 25 Nm
- Refer to: ENGINE UNDERSHIELD