LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> XF S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transfer Case -- XF/(X260)) >> Transfer Case - Vehicles With: 8HP45 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission AWD >> General Procedures >> Transfer Case Draining And Filling >> Filling

Transfer Case Draining And Filling: Filling

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    NOTE: Discard the sealing washer.
    G11314248Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the upper level plug.

  2. Refill transfer case with the recommended fluid, until the fluid is level with bottom of filler/level plug hole.
  3. CAUTION: Make sure that a new sealing washer is installed.
    NOTE: Make sure that all the component mating faces are clean.
    G11314248Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install the upper filler/level plug

    Renew Part: Transfer case drain plug washer  Quantity: 1  .

    Torque  : 8 Nm 

  4. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    G11314247Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the lower filler/level plug.

  5. Refill transfer case with the recommended fluid, until the fluid is level with bottom of filler/level plug hole.
  6. CAUTION: Make sure that the area around the component is clean and free of foreign material.
    G11314247Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Install the lower filler/level plug

    Torque  : 25 Nm 

  7. Refer to: ENGINE UNDERSHIELD
  8. NOTE: This step must be completed before road testing the vehicle.
    • Connect the Jaguar Land Rover (JLR) approved diagnostic equipment.

      General Equipment: Jaguar Land Rover approved diagnostic equipment 

    • Connect the JLR approved battery support unit.

      General Equipment: Jaguar Land Rover approved battery support unit 

    • Run the 'Pump Venting' routine.
    • Check for Transfer Case Control Module (TCCM) software updates.
    • Update TCCM software if required.
    • Disconnect the JLR approved diagnostic equipment.
    • Disconnect the JLR approved battery support unit.
  9. Drive the vehicle for approximately 2 Km (1.2 miles) including parking maneuvers and reversing.
scientia non olet · About LEMON Manuals