2.1 Retailer Showroom/Demonstration Vehicles
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
Vehicles used as retailer demonstrator(s), in a showroom, must be connected to a JLR approved showroom conditioner capable of delivering 50 Amps. This will prevent the battery from being damaged.
Vehicles used as retailer demonstrator(s), in a showroom, must be taken out of transit mode or have the transit relay removed. For additional information on the transit relay installation, refer to the Transit Relay Installation Summary table .
Vehicles used as retailer demonstrator(s), in a showroom, must have the starter motor, horn and wiper fuses removed as a minimum. The location of these fuses and if further fuses require removal.
For additional information, refer to: Showroom Preparation .
WARNING:
Showroom conditioners are only required to be turned on during showroom opening hours, outside these hours switch of all showroom conditioners.
NOTE:
For retailers who do not have floor sockets installed in the showroom a slave battery process has been outlined below. The slave battery process is only a TEMPORARY process until floor sockets are installed into the showroom. The retailer is responsible for making sure the process is set up and is also responsible for the procurement of slave batteries and other supporting equipment. The retailer is also responsible for developing a conformance plan to install floor sockets.