LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Pre DPF Exhaust Gas Temperature Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pre Diesel Particulate Filter (DPF) exhaust gas temperature sensor.
    CAUTION:
    • If accidentally dropped or knocked install a new sensor.
    • Make sure the anti-seize compound is applied only to the thread and does not contact the sensor body.

    Torque Specification: 35 Nm 

  2. Connect and secure the pre DPF exhaust gas temperature sensor wiring harness.
  3. Install the engine cover.
scientia non olet · About LEMON Manuals