Transmission - INGENIUM I4 2.0L Diesel (G1902043): Installation: Part(S)

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

STEP	PART NAME	QUANTITY
Step 16	Driveshaft flange bolts	6
Step 19	Torque converter bolts	4
Step 26	Transmission fluid cooler tubes to transmission O-ring seals	2

CAUTION: New transmission assemblies are supplied pre-filled with transmission fluid.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some illustrations may show the transmission removed for clarity.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: Make sure that the torque converter is fully engaged to the transmission.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: This step is only required if previously removed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: This step is only required if previously removed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 12Nm
WARNING: This step requires the aid of another technician.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 43Nm
NOTE: This step is only required if previously removed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 48Nm
WARNING: This step requires the aid of another technician.
CAUTION:
- Care must be taken to avoid damaging the surrounding components.
- Make sure that the torque converter remains in the transmission.
NOTE: Remove and discard the cable ties securing the torque converter.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 48Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 48Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 48Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 45Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the jack supporting the transmission.
CAUTION: Care must be taken not to damage the component.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Secure with a cable tie.
NOTE: Make sure that you re-align the driveshaft to the transmission flange using the alignment mark.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Discard the bolt.

NOTE: Mark the position of the driveshaft on the transmission flange.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Driveshaft flange bolts Quantity: 6 .

Torque : 75Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the cable tie.
CAUTION: Make sure that new bolts are installed.

NOTE: Only turn the engine in the normal direction of rotation.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Torque converter bolts Quantity: 4 .

Torque : 63Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: To prevent water ingress and subsequent transmission damage, make sure that the breather is fully pushed home into the transmission casing. The white line around the circumference of the pipe should not be visible when correctly installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the 4 cable ties.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the 4 cable ties.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 11Nm
NOTE: Install new O-ring seals.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Transmission fluid cooler tubes to transmission O-ring seals Quantity: 2 .

Torque : 22Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 22Nm
NOTE: Make sure that these components are installed to the noted removal position.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 7Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 9Nm
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL EXHAUST FLUID
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL EXHAUST FLUID
Refer to: FRONT DRIVESHAFT
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Special Tool(s): JLR-303-1633
- Special Tool(s): 303-021
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Torque : 30Nm
- Torque : 25Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 26Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque : 48Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Refer to: COWL PANEL
Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL
Refer to: TRANSMISSION FLUID LEVEL CHECK
- NOTE: Vehicles to the end of 17MY.
  
  If a new Transmission Assembly is installed. The Jaguar Land Rover approved diagnostic equipment must be used to calibrate the module.
- NOTE: Vehicles from introduction of 18MY.
  
  If a new Transmission Assembly is installed. The Jaguar Land Rover approved diagnostic equipment must be used to calibrate the module.
- Select 'Transmission Control Module [TCM]'
- Select 'Replace ECU'
- Follow all on-screen instructions to complete this task.