Pinpoint Test A: Source Tests

TEST CONDITIONS 

DETAILS/RESULTS/ACTIONS 

1. A1: SOURCE TEST 1 

   Soft key confirmation tones will not be audible if this preference is set to off (Set-up/System/Button feedback)

   1. Operate the available soft keys

   Was there an audible confirmation tone to indicate that the soft key input was detected?

   • Yes  : Audio amplifier module and MOST network functioning. GO to A2.
   • No  : Audio amplifier module fault or MOST ring break. GO to A2.
2. A2: SOURCE TEST 2 
   NOTE:

   • Operating the steering wheel mode switch briefly will cycle through the audio/video sources as follows: Radio - DAB/SDARS - My Music - My Video
   • Operating the steering wheel mode switch for >2 seconds will cycle through the minor sources as follows: (Radio) FM1 - FM2 - FM3 - AM1 - AM2, and (My Music) DVD/CD - iPod® - BT - Stored CDs - USB - AUX
   • Depending on vehicle specification, various audio/video sources may be installed and are contained in the control modules as follows:
     • Audio head unit (AHU)
     • Integrated audio module (IAM) - including radio, CD, iPod®, USB, my music, my video, phone and navigation
     • Digital radio control module (DRCM)
     • Satellite radio control module (SRCM)
     • TV control module (TVCM)
   1. Cycle through the audio/video sources by operating the steering wheel mode switch

   Did the audio/video soft key return to normal and/or the selected source function normally?

   • Yes  : MOST network functioning. GO to A3.
   • No  : Possible MOST ring break. GO to A3.
3. A3: SOURCE TEST 3 
   1. Operate the Navigation  soft key (or switch)

   Did the navigation system start up and display a map?

   • Yes  : GO to A4.
   • No  : GO to A4.
4. A4: SOURCE TEST 4 
   • Operate the Phone  soft key (or switch)

   Is the phone menu displayed?

   • Yes  : GO to Pinpoint Test B .
   • No  : GO to Pinpoint Test B .

     NOTE: