LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> XF S >> Repair and Diagnosis >> Accessories & Equipment >> Warning Systems >> Parking Aid -- XF/(X260) >> Parking Aid (G1817327) >> Removal And Installation >> Front Parking Aid Camera (G1817330) >> Installation

Front Parking Aid Camera (G1817330): Installation

  1. NOTE: Make sure that the component is correctly located on the locating dowels

    Install the front parking aid camera.

  2. Connect the electrical connector.
  3. Install the front bumper.

    Refer to: FRONT BUMPER

    • Following the replacement of a camera on these vehicles the calibration process is:
    • Drive the vehicle for 5 to 10 minutes as much as possible in a straight line, up to 30kph/19mph, during this time the camera will self-calibrate (do not have the camera functions turned on) to be carried out in normal daylight conditions.
    • After completing the drive cycle camera operation can be checked by:
    • Surround View Camera: To check calibration parked next to a kerb/line select camera view make sure a straight line is visible on screen in the 360 plan view
    • Standalone Rear Camera To check calibration reverse straight into a marked parking slot and see trajectory overlays are parallel to the markings on the ground
scientia non olet · About LEMON Manuals