Rear Air Spring (G2219849): Removal
WARNING:
Residual air pressure may be present in the system. Take care when releasing Airline connectors.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material.
When disconnected all openings must be sealed.
When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains illustrations for right side components, left side components are similar.
- Using Jaguar Land Rover approved diagnostic equipment, depressurize the air suspension system. Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE .
General Equipment : Jaguar Land Rover approved diagnostic equipment
- Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the rear wheel arch liner.
Refer to: REAR WHEEL ARCH LINER .
Disconnect the Airline connector.
-
NOTE: Note the position of the air spring before removal.
Remove the rear air spring.