Air Suspension Compressor (G2207034): Removal

WARNING: Residual air pressure may be present in the system. Take care when releasing Airline connectors.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material.

When disconnected all openings must be sealed.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Using Jaguar Land Rover approved diagnostic equipment, depressurize the air suspension system.
Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE .

General Equipment : Jaguar Land Rover approved diagnostic equipment
Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the loadspace lower trim.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the charging cable.
- Remove the tow eye.
- Remove the tire repair kit.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- CAUTION: Discard the retaining clips.
Remove the 4 clips.
- Remove the loadspace liner tray.
CAUTION: Do not reuse the Airline connector. Always install a new Airline connector every time it is released.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the 2 electrical connectors.
- Disconnect the Airline connector.
- Release the harness clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 nuts.
- Remove the air suspension compressor.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tape, cover the Airline and electrical connector openings.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using a 4 mm drill, remove the head of the rivets.
General Equipment : Air/Electric/Rechargeable drill

General Equipment : 4 mm drill bit
- Using a suitable tool, release the rivet bodies.
General Equipment : 2 mm punch
- Remove the outer cover.
CAUTION: Do not pull on the suspension air supply unit connectors to release the clips.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the inner assembly from the outer assembly.
- Remove the Noise, Vibration and Harshness (NVH) material.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using a 4 mm drill, remove the head of the rivets.
General Equipment : Air/Electric/Rechargeable drill

General Equipment : 4 mm drill bit
- Using a suitable tool, release the rivet bodies.
General Equipment : 2 mm punch
- Remove the inner cover.
Remove all drilling debris.
CAUTION: Do not reuse the Airline connector. Always install a new Airline connector every time it is released.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the Airline and discard the Airline connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 3 mounting bolts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the wiring harness.