Air Reservoir (G2217481): Removal
WARNING:
- This procedure can only be completed after the vehicle has been powered down by an approved person.
- Residual air pressure may be present in the system. Take care when releasing Airline connectors.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material.
When disconnected all openings must be sealed.
When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
-
WARNING: Jaguar Land Rover Electric Vehicle Competent Person (EVCP) trained technicians only.
This procedure involves work on components associated with the High Voltage (HV) system. Only technicians qualified to EVCP level or higher are allowed to perform this procedure. It is mandated that all technicians involved with the steps in this procedure have read and understood the Electric Vehicle Safety Rules.
Refer to: ELECTRIC VEHICLE SAFETY RULES .
- Using Jaguar Land Rover approved diagnostic equipment, depressurize the air suspension system.
Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE .
General Equipment : Jaguar Land Rover approved diagnostic equipment
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the rear subframe assembly.
Refer to: REAR SUBFRAME - REMOVE FOR ACCESS .
- CAUTION: Do not reuse the Airline connector. Always install a new Airline connector every time it is released.
Disconnect the Airline connector.
- Release the clip.
- Remove the 4 bolts.