Rear Right Temperature Blend Motor (G2225329): Installation

WARNING: This page is about a different car, the 2021 Jaguar I-Pace, 2020 Jaguar I-Pace, and 2019 Jaguar I-Pace. However, it is still accessible from the selected car via links, so may be relevant.

The following step(s) applies to:

All vehicles

CAUTION: Make sure that these components are installed to the noted removal position.
- Install the distribution motor.
- Install and tighten the 3 screws.
  Torque : 1.5Nm
- Connect the electrical connector.
The following step(s) applies to:

Left-hand drive vehicles
Remove the glovebox.
Refer to: GLOVEBOX .

The following step(s) applies to:

Right-hand drive vehicles
Install the instrument panel lower trim panel.
Refer to: INSTRUMENT PANEL LOWER TRIM PANEL .