Integrated Control Panel (G2219030): Installation

WARNING: This page is about a different car, the 2021 Jaguar I-Pace, 2020 Jaguar I-Pace, and 2019 Jaguar I-Pace. However, it is still accessible from the selected car via links, so may be relevant.

- Connect the 3 electrical connectors.
- Install the Integrated Control Panel (ICP).
- Install and tighten the 4 bolts.
  Torque : 8Nm
Install the floor console front upper trim.
- Connect the 2 electrical connectors.
- Install the Jaguar Drive Switchpack (JDS).
- Install the 8 screws.
- Install the trim.
- Install the 2 screws.
Install the Floor console rubber mat.
- Install the floor console upper surrounding trim.
- Install the 2 screws.
- Install the 2 rubber bump stops.
Install the cup holder.
- Install the armrest.
- Install the 8 screws.
- Install the clip.
- Connect the 3 electrical connectors.
- Connect the 4 electrical connectors.
- Install the floor console rear surround trim.
Install the floor console.
NOTE: Repeat this step for the other side.
- Install and tighten the 3 bolts.
  Torque : 8Nm
- Install the screw.
- Install the 2 clips.
- Connect the 4 electrical connectors.
- Install the clip.
- Connect the 2 electrical connectors.
- Install the floor console front lower trim.
- Install the floor console rear lower trim.
- Connect the 4 electrical connectors.
NOTE: Repeat this step for the other side.

Install the access panel.
Remove the front row seats.
Refer to: FRONT ROW SEAT - VEHICLES WITH: POWER SEATS .
Disconnect the startup battery ground cable.
Refer to: 12V SYSTEM DISCONNECT .
Remove the floor console surround trim.
Refer to: FLOOR CONSOLE SURROUND TRIM .