LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> I-Pace >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Climate Control -- I-Pace/X590) >> Climate Control (G2244547) >> Removal And Installation >> HVAC Control Module (G2309658) >> Installation

HVAC Control Module (G2309658): Installation

WARNING: This page is about a different car, the 2021 Jaguar I-Pace, 2020 Jaguar I-Pace, and 2019 Jaguar I-Pace. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the HVAC  control module.
    • Install and tighten the 2 screws.
    • Connect the 4 HVAC  control module electrical connectors.
  2. Reposition the air duct.
  3. Install the glovebox.

    Refer to: GLOVEBOX .

  4. NOTE:
    • This step is only required if a new component is installed.
    • SRO to be claimed separately.
    • Use the Jaguar Land Rover (JLR) approved diagnostic equipment to configure the new module.

      General Equipment: Jaguar Land Rover approved diagnostic equipment 

    • Follow all on-screen instructions to complete this task.
scientia non olet · About LEMON Manuals