Electric Park Brake Actuator (G2214071): Removal
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Connect the Jaguar Land Rover approved diagnostic equipment and set the Electric Park Brake (EPB) to the maintenance position.
General Equipment : Jaguar Land Rover approved diagnostic equipment
-
NOTE: This step is only required if the diagnostic tool is not available.
Release the EPB.
Refer to: ELECTRIC PARK BRAKE RELEASE .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
- Remove the rear wheel and tire assembly.
Refer to: WHEEL AND TIRE .
Disconnect the EPB actuator electrical connector.
- Remove the EPB actuator and discard the bolts.
- Discard the O-ring seal.