LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> I-Pace >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumpers -- I-Pace/X590 >> Bumpers [G2152356] >> Removal And Installation >> Front Bumper [G2202023] >> Installation

Front Bumper [G2202023]: Installation

    • Install the air deflectors.
    • Install the 8 push pins.
  2. NOTE: Make sure that all the clips are correctly installed.
    • Install the front bumper air intakes.
    • Install and tighten the 6 screws.
    • Install the 2 outer brackets.
    • Install and tighten the 12 screws.
  4. NOTE: Make sure that all the clips are correctly installed.
    • Install the radiator grille upper molding.
    • Install and tighten the 6 screws.
  5. NOTE: Make sure that all the clips are correctly installed.

    Install the radiator grille.

  6. NOTE: Make sure that all the clips are correctly installed.
    • Install the radiator grille support.
    • Install and tighten the 9 screws.
  7. CAUTION: Make sure that the component is correctly located on the locating dowels.

    Install the front proximity camera.

  8. NOTE: Make sure that all the clips are correctly installed.
    • Install the 4 parking aid sensors.
    • Install the 2 park assist sensors.
    • Install the ASCM.
    • Install and tighten the 4 screws.
    • Install the front fog lamps.
    • Install and tighten the 6 screws.

      Torque  : 2Nm 

  11. NOTE: Make sure that all the clips are correctly installed.
    • Install the washer hose with the washer jet on the left side.
    • Install the right side washer jet.
    • Install and tighten the 4 screws.

      Torque  : 1.5Nm 

    • Install the washer jet covers.
  12. NOTE: Make sure that the clips are installed in the correct orientation.
    • Install the front bumper harness.
    • Connect the 10 electrical connectors.
  13. CAUTION: Four audible clicks are heard when the clips are fully located.
    • Install the pedestrian protection system bracket.
    • Install the 2 pedestrian protection system pressure sensors.
    • Install and tighten the 2 screws.

      Torque  : 5Nm 

    • Connect the 2 electrical connectors.
  14. CAUTION:
    • Make sure that the vehicle paintwork is protected.
    • Two audible clicks are heard when the clips are fully located.
    • With assistance, install the front bumper.
    • Install and tighten the 4 outside bolts.

      Torque  : 10Nm 

    • Install and tighten the 2 screws.
  15. Install the front bumper lower 3 screws.
  16. NOTE: Right side only.

    Connect the 2 washer jet hoses.

  17. NOTE:
    • Right side only.
    • Make sure that all the clips are correctly installed.

    Connect the 3 electrical connectors.

    • Install the front section of the wheel arch liners on both sides.
    • Install the 4 clips.
    • Install and tighten the 6 bolts.
  19. Lower the vehicle.
    • Install and tighten the front bumper upper 10 screws.

      Torque  : 1.5Nm 

    • Install the clip.
  21. NOTE: Make sure that all the clips are correctly installed.
    • Install the front compartment left trim panel.
    • Install the small trim panel.
    • Install the strut.
  22. Install the front compartment right trim panel.

    Refer to: FRONT COMPARTMENT RIGHT TRIM PANEL .

scientia non olet · About LEMON Manuals