Instrument Cluster (G2219031): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.
When a new instrument cluster is to be installed, the Land Rover approved diagnostic system must be connected to the vehicle and the instrument cluster renewal procedure followed.
For non-NAS markets - If a new instrument cluster is to be installed, a new Remote Function Actuator (RFA) will be required. All vehicle keys must be presented to complete the RFA renewal.

NOTE: Only complete this step if a new instrument cluster is to be installed.

Use the Jaguar approved diagnostic equipment to collect information from the instrument cluster.

General Equipment: Jaguar diagnostic equipment
CAUTION: If the software number is K8D2-14C104-AC or L8B2-14C104-AC, a new RFA will be required.

NOTE: Non-NAS Markets only.

Using the Jaguar diagnostic equipment, read the RFA software number.

General Equipment: Jaguar diagnostic equipment
Remove the driver side face level vent.
Refer to: DRIVER SIDE VENT .
Remove the center vent trim panel.
Refer to: CENTER VENT TRIM PANEL .
Remove the In-vehicle temperature sensor.
Refer to: IN-VEHICLE TEMPERATURE SENSOR .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the trim panel.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the access cover.
- Remove the 3 screws.
CAUTION: Do not use excessive force to remove the component. Make sure that all fixings are fully released.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Carefully release the 4 clips.
- Remove the instrument cluster surrounding trim panel.
CAUTION: Take extra care not to damage the instrument cluster face.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC