Toe Link - Vehicles With: PHEV (G2806793): Installation

CAUTION: Only fully tighten the nut when the wheel alignment has been checked and is within specification.
- Install the bolt.
- Install and tighten the nut.
  Torque
  
  Stage 1: 60 Nm
  
  Stage 2: 90°
CAUTION: Only fully tighten the nut when the wheel alignment has been checked and is within specification.
- Install the new bolt.
  Renew Part: Toe link to knuckle bolt(s) Quantity: 1 .
- Install and tighten the new nut.
  Renew Part: Toe link to knuckle nut(s) Quantity: 1 .
  
  Torque
  
  Stage 1: 80 Nm
  
  Stage 2: 60°
NOTE: Steps 3 - 4 are only applicable to the left side component.

Install the HV integrated box.

Refer to: HIGH VOLTAGE INTEGRATED BOX
Power up the HV system. Only technicians qualified to EVAP level or higher are allowed to perform this procedure. It is mandated that all technicians involved with the steps in this procedure have read and understood the EV Safety Rules.
Refer to: PHEV POWER DOWN/UP - COMPLETE VEHICLE - PATHFINDER
NOTE: Steps 5 - 7 are only applicable to the right side component.
- Install the right undershield.
- Install and tighten the 3 nuts.
  Torque : 8 Nm
- Install and tighten the 6 bolts.
  Torque : 8 Nm
- Install the 9 fasteners.
- Install the rear center undershield.
- Install and tighten the 4 nuts.
  Torque : 8 Nm
- Install and tighten the 2 bolts.
  Torque : 8 Nm
- Install the rear wheel arch air deflector.
- Install the 3 fasteners.
NOTE: Using Jaguar Land Rover approved equipment, check and if necessary adjust the wheel alignment. SRO must be claimed separately.

Check the rear wheel alignment and adjust if required.

Refer to: WHEEL ALIGNMENT