LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> F-Pace R-Dynamic S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- F-Pace/X761) >> Electronic Engine Controls - V8 S/C 5.0L Petrol (G1917122) >> Removal And Installation >> Manifold Absolute Pressure Sensor (G2244157) >> Installation

Manifold Absolute Pressure Sensor (G2244157): Installation

WARNING: This page is about a different variant/trim than selected.
    • Install the Manifold Absolute Pressure (MAP) sensor.
    • Install and tighten the bolt.

      Torque  : 5 Nm 

    • Connect the electrical connector.
  1. Install the vacuum pipe to the 2 clips.
    • Connect the vacuum pipe.
    • Install the vacuum pipe to the clip.
  2. Install the secondary bulkhead left inner panel.

    Refer to: SECONDARY BULKHEAD LEFT INNER PANEL - V8 S/C 5.0L PETROL

  3. Install the secondary bulkhead left outer panel.

    Refer to: SECONDARY BULKHEAD LEFT OUTER PANEL - V8 S/C 5.0L PETROL