Oil Pump - Vehicles With: PHEV (G2756534): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the 12V system.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Raise and support the vehicle on a suitable 2-post lift.
Refer to: LIFTING
Remove the oil pump drive chain.
Refer to: OIL PUMP DRIVE CHAIN - VEHICLES WITH: PHEV (G2756533)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the electrical connector.
- Release and push through the electrical connector across the cylinder block.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wiring harness at 3 clips.
- Remove the 4 bolts.
- Remove the oil pump.
- Remove and discard the O-ring seal from the electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the gasket from the oil pump.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 2 bolts.
- Remove the pickup pipe from the oil pump.
- Remove and discard the gasket.