Rear Fuel Line (G2266453): Installation

WARNING: This page is about a different variant/trim than selected.

The following step(s) applies to:

All vehicles

- Install and connect the fuel line.
- Secure the 4 clips.
- Using a suitable stand, support the fuel tank and connect the vapor pipe to the fuel tank.
  General Equipment: Transmission jack
- Install the fuel tank.
- Install the 2 fuel tank support straps.
- Install and tighten the 4 bolts.
  Torque : 25 Nm
- Install and tighten the nut.
  Torque : 25 Nm
NOTE: Repeat this step for the other side.
- Install the heatshield.
- Install and tighten the nut.
  Torque : 15 Nm
The following step(s) applies to:

Vehicles with fuel fired heater
- Connect the fuel line.
- Secure the retainer.
Connect the 2 fuel lines.
The following step(s) applies to:

All vehicles
- Install the heatshield.
- Install and tighten the 4 nuts.
  Torque : 3 Nm
- Install the fuel tank filler pipe.
- Secure the clamp.
  Torque : 3.5 Nm
Install the rear driveshaft.
Refer to: REAR DRIVESHAFT - V8 S/C 5.0L PETROL
Connect the startup battery.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Refill the fuel tank.