LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> F-Pace R-Dynamic S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- F-Pace/X761) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2006487) >> Removal And Installation >> Pre Catalyst Heated Oxygen Sensor (G2278737) >> Installation

Pre Catalyst Heated Oxygen Sensor (G2278737): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: Make sure the anti-seize compound does not contact the tip of the Heated Oxygen Sensor (HO2S).
    NOTE: If the original sensor is to be installed, apply Castrol Optimol Paste MF or Bostic Never-Seez Regular Grade NS42B to the thread of the Heated Oxygen Sensor (HO2S).

    Using the special tool, install the Heated Oxygen Sensor (HO2S).

    Special Tool(s): JLR-303-1666 

    Torque  : 48 Nm 

  2. Connect the HO2S electrical connector.
  3. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals