Intake Camshaft Position Sensor (G2020274): Installation
WARNING: This page is about a different variant/trim than selected.
- NOTE: Apply a thin film of Castrol Classic GP-50 to the camshaft position sensor bore.
- Install the intake camshaft position sensor.
Renew Part: Camshaft position sensor O-ring seal Quantity: 1 .
- Install and tighten the bolt.
Torque : 8 Nm
- Install the intake camshaft position sensor.
-
- Connect the electrical connector.
- Connect the breather pipe.
- Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT (G2623442) .