LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> F-Pace R-Dynamic S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- F-Pace/X761) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2006487) >> Removal And Installation >> Fuel Rail Pressure Sensor (G2289191) >> Installation

Fuel Rail Pressure Sensor (G2289191): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Authoring Template
  2. CAUTION: Make sure threads are clean and free from petrol.

    Install the fuel rail pressure sensor. Lubricate the threads with Molykote W15.

    Torque  : 38 Nm 

  3. Connect the electrical connector to the fuel rail pressure sensor.
  4. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .

  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT (G2623442) .

scientia non olet · About LEMON Manuals