Throttle Body (G2269166): Installation

WARNING: This page is about a different variant/trim than selected.

- Install the throttle body with a new gasket.
  Renew Part: Throttle body gasket Quantity: 1 .
- Install the 2 coolant hoses.
- Secure the 2 clamps.
Install and tighten the 4 bolts.
Torque : 10 Nm
Connect the 2 electrical connectors.
- Install a new O-ring seal to the coolant pipe.
  Renew Part: Water outlet connection O-ring seals Quantity: 1 .
- Install the coolant pipe.
- Install and tighten the 2 bolts.
  Torque : 10 Nm
- Reposition the wiring harness and secure the clip.
- Connect the 2 hoses.
- Secure the 2 clamps.
Connect the breather pipe to the supercharger.
Install the air filter outlet pipe T-connector.
Refer to: AIR FILTER OUTLET PIPE T-CONNECTOR .
Fill the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .