Rear Coolant Manifold (G2368793): Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: This step is only required if new components are not installed.

Install 2 new O-ring seals to the rear coolant manifold.

Renew Part: Cylinder block coolant outlet O-ring seals Quantity: 2 .
- Install the rear coolant manifold.
- Install and tighten the 4 bolts.
  Torque : 9 Nm
- Connect the electrical connector.
- Install the wiring harness clip.
- Connect the rear coolant manifold left hose.
- Install the coolant hose clip.
Connect the rear coolant manifold right hose.
Install the secondary bulkhead left outer panel.
Refer to: SECONDARY BULKHEAD LEFT OUTER PANEL - V8 S/C 5.0L PETROL
Install the secondary bulkhead right outer panel.
Refer to: SECONDARY BULKHEAD RIGHT OUTER PANEL - V8 S/C 5.0L PETROL
Vacuum fill the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING