Left Engine Mount (G2271575): Installation

WARNING: This page is about a different variant/trim than selected.

Install the left engine mount.
WARNING: Make sure the engine is properly located on the engine mounts.

Lower the engine.
CAUTION: Only tighten the bolts and the nut finger tight at this stage.
- Install, but only finger tighten the 2 left engine mount bolts.
- Install, but only finger tighten the left engine mount nut.
Install, but only finger tighten the right engine mount nut.
- Install the Air Conditioning (A/C) compressor.
- Install and tighten the 3 bolts.
  Torque : 25 Nm
- Connect the A/C compressor electrical connector.
- Install the wiring harness clip.
CAUTION: Make sure that the accessory drive belt is correctly routed around all of the pulleys.

Install the accessory drive belt.
- Install the automatic transmission fluid cooler bracket.
- Install and tighten the 2 bracket bolts.
  Torque : 5 Nm
- Install the automatic transmission fluid cooler.
- Install and tighten the bolt.
  Torque : 5 Nm
NOTE: This step must be done on both sides.
- Fully tighten the 2 engine mount bolts at both sides.
  Torque : 47.5 Nm
- Fully tighten the engine mount nut at both sides.
  Torque : 60 Nm
Install the engine undershield.
Refer to: ENGINE UNDERSHIELD - V8 S/C 5.0L PETROL
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT