DTC P0333-12: Knock/Combustion Vibration Sensor 2 Circuit High Bank 2 - Circuit short to battery: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to Enable DTC Setting Strategy
- Normal driving
- Prioritized Checks to Perform
- Refer to the electrical circuit diagrams and check the knock sensor circuit for short circuit to power. Check the electrical connectors for evidence of water ingress. Check the terminals for damage and corrosion. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, run application - ECU Diagnostics/Powertrain Control Module (PCM)/Clear Diagnostic Trouble Code(s). Retest
- Check the resistance of the knock sensor (should be greater than 4 mega-ohms). Install a new knock sensor as necessary