DTC P0096-23: Intake Air Temperature Sensor 2 Circuit Range/Performance Bank 1 - Signal stuck low: Action
WARNING: This page is about a different variant/trim than selected.
- Vehicle Conditions to Enable DTC Setting Strategy
- Engine off for greater than 8 hours. Drive steady state conditions above 72 km/h for 30 seconds (x3) and steady state below 5 km/h (x3) for 30 seconds
- Prioritized Checks to Perform
- Refer to the electrical circuit diagrams and check the charge air pressure and temperature sensor circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Check the electrical connectors for evidence of water ingress. Check the terminals for damage and corrosion. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, run application - ECU Diagnostics/Powertrain Control Module (PCM)/Clear Diagnostic Trouble Code(s). Retest