LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2022 >> F-Pace Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- F-Pace/X761 (Specifications - Removal & Installation) >> Engine - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2412673) >> Removal And Installation >> Oil Pump Drive Chain - Vehicles With: PHEV (G2756533) >> Removal

Oil Pump Drive Chain - Vehicles With: PHEV (G2756533): Removal

NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the 12V system.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  2. Raise and support the vehicle on a suitable 2-post lift.

    Refer to: LIFTING

  3. Remove the oil pan.

    Refer to: OIL PAN - AWD (G2498224) 

  4. CAUTION: Discard the bolt.
    G15617724Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Install the special tool.

      Special Tool(s): 205-053 

    • Hold against the oil pump gear and remove the bolt.
    • Remove the special tool.
  5. NOTE: Note the installed position of the oil pump gear prior to removal.
    G15617725Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the oil pump drive chain with the gear.

scientia non olet · About LEMON Manuals