Instrument Panel Lower Trim Panel (G2502359): Installation

• Install the IAU  to the bracket.
• Install and tighten the screw.

  Torque  : 1.5 Nm 

• Install the lighting control switch.
• Make sure the 4 clips are correctly installed.

• Connect the 2 electrical connectors to the lighting control switch.
• Install the On-Board Diagnostics connector.
• Connect the electrical connector to the IAU. 
• Install the instrument panel lower trim panel.

• Install and tighten the 5 screws to the instrument panel lower trim.

  Torque  : 3.5 Nm 

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

• Install and tighten the screw to the instrument panel upper trim.

  Torque  : 3.5 Nm 

• Install and tighten the screw to the cross-car beam.

  Torque  : 9 Nm 

• Install the 2 clips.
• Install the instrument panel driver side trim.
• Make sure that the 6 clips are correctly installed.

• Install the 2 NVH  material dowels.
• Connect the electrical connector to the footwell lamp.
• Install the instrument panel lower trim.
• Install the 3 fasteners.

• Install the trim panel to the touchscreen bracket.
• Install the 2 clips.

• Install the 2 trim panels below the instrument cluster.
• Make sure that the 8 clips are correctly installed.

Refer to: FLOOR CONSOLE SIDE TRIM PANEL 

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT