Fender (G2172309): Installation

WARNING: This page is about a different car, the 2018 Jaguar E-Pace. However, it is still accessible from the selected car via links, so may be relevant.

Install the side vent.
CAUTION: Only tighten the bolts finger tight at this stage.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the front fender.
- Install the 3 bolts.
CAUTION: Only tighten the bolts finger tight at this stage.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the front bolt.
CAUTION: Only tighten the bolts finger tight at this stage.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the 2 bolts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- NOTE: Make sure that the gap around the component is even.
  
  Align the fender.
- Tighten the 7 bolts.
  Torque : 10 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the baffle plate.
- Install the clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the foam pad.
- Install the clip.
Install the insulation.
Install the front wheel arch liner.
Refer to: FRONT WHEEL ARCH LINER .
Install the front bumper.
Refer to: FRONT BUMPER .