Parking Brake Release Actuator (G2174389): Installation

1. CAUTION: A new O-ring seal is to be installed.
   • Install the Electric Park Brake (EPB) actuator.

     Renew Part: Electric park brake actuator O-ring seal Quantity: 1  .

   • Install and tighten the 2 bolts.

   Torque  : 11 Nm 

2. NOTE: Make sure the wiring harness is routed correctly.
   • Connect and secure the wiring harness.
3. NOTE: This step is only required if the diagnostic tool is not available.

   Deactivate the service mode function of the EPB.

   Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .

4. NOTE: This step is only required if the vehicle has no battery power.

   Deactivate the service mode function of the EPB.

   Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL POWER .

5. Calibrate the EPB using the diagnostic tool.

General Equipment: Jaguar diagnostic equipment