Brake Booster (G2174346): Installation

The following step(s) applies to:

All vehicles

- Install the brake booster.
- Connect the brake booster vacuum hose to the brake booster.
- Install and tighten the 4 nuts.
  Torque : 25 Nm
- CAUTION: Make sure that a new brake pedal plastic pin is installed.
Attach the brake booster push rod to the brake pedal.

Renew Part: Brake booster to brake pedal pin Quantity: 1 .

The following step(s) applies to:

Right-hand drive vehicles
WARNING: Make sure that the area around the component is clean and free of foreign material.
- Install the brake pipes.
Torque : 17 Nm

The following step(s) applies to:

Left-hand drive vehicles
WARNING: Make sure that the area around the component is clean and free of foreign material.
- Connect the brake pipes to the Hydraulic Control Unit (HCU).
Torque : 17 Nm
CAUTION: Make sure that the wiring harness is correctly routed.
- Install the Powertrain Control Module (PCM).
- Install and tighten the 2 nuts.
Torque : 9 Nm
Install the startup battery tray.
Refer to: STARTUP BATTERY TRAY .

The following step(s) applies to:

All vehicles
Install the brake master cylinder.
Refer to: BRAKE MASTER CYLINDER .
Install the windshield wiper motor assembly.
Refer to: WINDSHIELD WIPER MOTOR .
Install the instrument panel lower trim panel.
Refer to: INSTRUMENT PANEL LOWER TRIM PANEL .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .
Bleed the brake system.
Refer to: BRAKE SYSTEM BLEEDING .

The following step(s) applies to:

Vehicles with manual transmission
Bleed the clutch hydraulic system.

Refer to: CLUTCH SYSTEM BLEEDING .