Brake Master Cylinder (G2172299): Removal

CAUTION:

- If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
Make sure the brake pipes are not damaged when displacing the brake master cylinder and ABS module. Failure to follow this instruction may result in damage to the vehicle.

The following step(s) applies to:

All vehicles

Raise and support the vehicle on a suitable 2 post lift.
Refer to:LIFTING (G189141)
Remove the brake fluid reservoir.
Refer to: BRAKE FLUID RESERVOIR .

The following step(s) applies to:

Right-hand drive vehicles
Remove the secondary bulkhead center panel.
Refer to: SECONDARY BULKHEAD CENTER PANEL - INGENIUM I4 2.0L DIESEL .

Refer to: SECONDARY BULKHEAD CENTER PANEL - INGENIUM I4 2.0L PETROL .

The following step(s) applies to:

All vehicles
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the 2 brake pipes.
CAUTION: Discard the seal and the retaining nuts.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the brake master cylinder.