Transmission Fluid Cooler - INGENIUM I4 2.0L Petrol: Removal

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING

General Equipment: 2 post lift
Drain the transmission fluid system.
Refer to: TRANSMISSION FLUID DRAIN AND REFILL
Drain the coolant system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 3 clips securing the lower fender splash shield to the vehicle body.
- Remove the front left lower fender splash shield.
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 2 coolant pipes from the transmission cooler assembly.
CAUTION: Be prepared to collect escaping fluid.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the 2 transmission cooler tubes from the transmission cooler assembly.
CAUTION: Be prepared to collect escaping fluid.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the bolt securing the transmission oil cooler assembly to the bracket.
Remove the transmission fluid cooler.