Wheel Alignment Specification - Rear comfort
CAUTION:
Both tie-rods must be rotated by an equal amount.
NOTE:
All figures are with vehicle at 'Showroom' ride height - full fluids, full tank of fuel, no occupants/luggage, tires inflated to normal pressures
| ITEM | UNITS | LEFT | RIGHT | TOTAL/BALANCE | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Camber | Nominal | Tolerance | Min/Max | Nominal | Tolerance | Min/Max | Nominal | Tolerance | Min/Max | |
| Decimal degrees | -0.94° | ± 0.75° | -1.69°/-0.19° | -0.94° | ± 0.75° | -1.69°/-0.19° | 0.0° | ± 0.75° | -0.75°/0.75° | |
| Degrees/Minutes | -56' | ± 0.45' | -1°41'/-11' | -56' | ± 0.45' | -1°41'/-11' | 0' | ± 0.45' | -45'/45' | |
| Toe | Nominal | Tolerance | Min/Max | Nominal | Tolerance | Min/Max | Nominal | Tolerance | Min/Max | |
| Decimal degrees | 0.08° | ± 0.08° | 0.00°/0.16° | 0.08° | ± 0.08° | 0.00°/0.16° | 0.16° | ± 0.14° | 0.02°/0.30° | |
| Degrees/Minutes | 4.7' | ± 5' | 0'/10' | 4.7' | ± 5' | 0'/10' | 9' | ± 8' | 1'/18' | |
| Thrust angle | Nominal | Tolerance | Min/Max | Nominal | Tolerance | Min/Max | Nominal | Tolerance | Min/Max | |
| Decimal degrees | - | - | - | - | - | - | 0.0° | ± 0.06° | -0.06°/0.06 | |
| Degrees/Minutes | - | - | - | - | - | - | 0' | ± 4' | -4'/4' | |