Removal And Installation: Installation

All vehicles 

1. CAUTION:

   • Make sure that the mating faces are clean and free of foreign material.
   • Make sure the anti-seize compound does not contact the HO2S tip.
   NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

   Torque Specification: 45 Nm 

2. NOTE: Install a new gasket.

   Special Tool(s):  303-1444-01

3. NOTE: If a new cylinder head is installed use the special tools in the illustration.

   Special Tool(s):  303-1444-02

4. CAUTION: Make sure that new bolts are installed.
   NOTE: Install the spacers in the noted position.

   Torque Specification: 10 Nm 

5. Remove the special tool.

6. NOTE: If equipped.

   Remove the special tool.

7. CAUTION: Make sure that new bolts are installed.
   NOTE: Install the spacers in the noted position.

   Torque Specification: 10 Nm 

8. CAUTION: Tighten the bolts in the sequence shown.
   Fig 1: Right Side Exhaust Manifold Bolts Tightening Sequence

   Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

   Torque Specification: 18 Nm 

9. Torque Specification: 3 Nm 

10. Torque Specification: 3 Nm 

11. Torque Specification: 25 Nm 

4WD vehicles 

1. Refer to: RIGHT ENGINE MOUNT - AWD  (Removal and Installation).

All vehicles 

1. Refer to: RIGHT CATALYTIC CONVERTER (Removal and Installation).
2. Refer to: ACCESSORY DRIVE BELT (Removal and Installation).
3. Connect the battery ground cable.

   Refer to: Battery Disconnect and Connect (General Procedures).