LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine - V6 S/C 3.0L Petrol >> Right Cylinder Head >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: Battery Disconnect and Connect (General Procedures).
  2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  3. Refer to: Secondary Bulkhead Panel LH - V6 S/C 3.0L Petrol (Removal and Installation).
  4. Refer to: Exhaust Manifold RH  (Removal and Installation).
  5. Refer to: Camshaft RH  (Removal and Installation).
  6. G11286580
  7. G11309715
  8. CAUTION: Be prepared to collect escaping coolant.
    G11286555
  9. CAUTION:
    • Be prepared to collect escaping coolant.
    • Remove and discard the seals.
    G11286556
  10. G11309718
  11. CAUTION: Remove and discard the engine oil filter.
    NOTE: Remove and discard the O-ring seal.
    G11309719
  12. NOTE: Remove and discard the gasket.
    G11284998
  13. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
    G11309721
  14. G11309722
  15. G11309723
  16. CAUTION: Discard the bolts.
    G11309724

    Special Tool(s):  303-1492

  17. NOTE: Discard the gasket.
    G11309725
scientia non olet · About LEMON Manuals