Exhaust System - Standard Wheelbase: Removal
WARNING: This page is about a different car, the 2020 Jaguar XF and 2019 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
The following step(s) applies to:
All vehicles
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: ENGINE UNDERSHIELD
The following step(s) applies to:
2WD vehicles
The following step(s) applies to:
4WD vehicles
The following step(s) applies to:
All vehicles
Torque
Stage 1: 10 Nm
Stage 2: 40 Nm
Torque
Stage 1: 10 Nm
Stage 2: 40 Nm
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.NOTE: Repeat the step for the other side.
Torque : 30 Nm
The following step(s) applies to:
2WD vehicles
-
NOTE: Do not disassemble further if the component is removed for access only.
Special Tool(s): 310-121
Torque : 48 Nm
The following step(s) applies to:
4WD vehicles
-
NOTE: Do not disassemble further if the component is removed for access only.
Special Tool(s): 310-121
Torque : 48 Nm
The following step(s) applies to:
All vehicles
-
CAUTION: Make sure that new bolts are installed.
Renew Part: Exhaust pipe rubber damper kit Quantity: 1 .
Torque : 22 Nm