Transmission Fluid Cooler Pipes - INGENIUM I4 2.0L Diesel: Removal
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
General Equipment: 2 post lift
- Drain the transmission fluid.
Refer to: TRANSMISSION FLUID DRAIN AND REFILL .
- Remove the 3 clips securing the lower fender splash shield to the vehicle body.
- Remove the front left lower fender splash shield.
-
CAUTION: Be prepared to collect escaping fluid.
Release the 2 transmission cooler tubes from the transmission cooler assembly.
Remove the bolt securing the transmission fluid cooler tubes to the oil pan assembly.
-
CAUTION:
- Be prepared to collect escaping fluid.
-
- Make sure that the area around the component is clean and free of foreign material.
- Remove and discard the O-ring seal.
Remove the bolt securing the transmission fluid cooler tubes to the transmission assembly.
-
CAUTION: Be prepared to collect escaping fluid.
Remove the transmission cooler tubes.