LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Fuel Tank & Lines - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Fuel Tank And Lines - INGENIUM I4 2.0L Diesel >> Auxiliary Fuel Pump >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Avoid flames, sparks or lighted substances.
  • Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.
  • Be prepared to collect escaping fuel.
CAUTION:
  • Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
  • Make sure that all openings are sealed. Use new blanking caps.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect .
  2. G11314761
  3. G11314762
  4. G11314763
  5. NOTE: Do not disassemble further if the component is removed for access only.
    G11314764

    Torque Specification: 10 Nm 

  6. NOTE: Discard the retaining clip.
    G11314765

    Renew Part: Hose clamp Quantity: 1

  7. G11314766

    Torque Specification: 10 Nm 

  8. G11314767
scientia non olet · About LEMON Manuals