LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine - V6 S/C 3.0L Petrol >> Engine Oil Vacuum Draining And Filling >> General Procedures >> Draining

General Procedures: Draining

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The spilling of hot engine oil is unavoidable during this procedure, care must be taken to prevent scalding.
CAUTION: Correct installation of the oil filler cap can be obtained by tightening the cap until hard stop.
NOTE:
  • Make sure that the vehicle is parked on level ground.
  • Clean the components general area prior to dismantling.
  • Some variation in the illustrations may occur, but the essential information is always correct. 
    • CAUTION: Make sure the engine is warm.

      Start the engine and allow to run for 10 minutes, stop the engine.

  2. Refer to: Engine Cover - V6 S/C 3.0L Petrol (Removal and Installation).
  3. CAUTION: Allow 10 minutes from turning the engine off before starting oil extraction.
    G11309553
  4. NOTE: Allow 10 minutes for the engine oil to drain from the oil filter housing.
    G11286696
  5. G11284835
    • Using the oil vacuum pump drain the oil out through the oil extraction tube.

      Special Tool(s):  303-1484, 303-1484-01

    • Remove the oil vacuum pump.
  7. NOTE: Remove and discard the O-ring seal.
    G11286697
  8. CAUTION: Remove and discard the oil filter element.
    G11309556
scientia non olet · About LEMON Manuals