LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine - V6 S/C 3.0L Petrol >> Engine - AWD >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Some illustrations may show the engine removed for clarity.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Remove and discard all blanking caps.
  1. G11310463

    Special Tool(s):  303-1435, 303-1436

    General Equipment:  Hydraulic jib crane

  2. CAUTION: Install a new nut.
    G11310362

    Torque Specification: 60 Nm 

  3. CAUTION: Install a new nut.
    G11310361

    Torque Specification: 60 Nm 

  4. NOTE: The procedure must be carried out on both sides.
    G11310359

    Special Tool(s):  303-1435

  5. G11310358

    Special Tool(s):  303-1436

  6. G11310357

    Torque Specification: 25 Nm 

  7. G11310356

    Torque Specification: 7 Nm 

  8. G11310355
  9. Raise the vehicle.
  10. G11310354

    Torque Specification: 10 Nm 

  11. G11310353

    Torque Specification: 12 Nm 

  12. CAUTION: Do not use excessive force to remove the component.
    G11310352
  13. G11310351

    Torque Specification: 25 Nm 

  14. G11310350
  15. G11310349
  16. G11310348
  17. WARNING: Be prepared to collect escaping fuel.
    G11310347
  18. G11310346
  19. G11310345
  20. G11310344
  21. G11310343
  22. G11310342
  23. G11310341
  24. Refer to: Automatic Transmission/Transaxle - AWD (Installation).
  25. Refer to: Front Halfshaft (Installation).
  26. Refer to: Front Halfshaft (Installation).
  27. Refer to: Cooling Fan Motor and Shroud (Installation).
  28. Refer to: Cooling System Draining And Vacuum Filling (General Procedures).
  29. Refer to: Battery Disconnect and Connect (General Procedures).
  30. Refer to: Hood (Installation).