Spring (G1817699): Removal

CAUTION:

To avoid damage to the Constant Velocity joint (CV) or CV boot, do not allow the halfshaft to hang.
Nuts and bolts must be tightened with vehicle at normal ride height

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
Refer to: REAR SHOCK ABSORBER
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION: Discard the nut and bolt.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Toe link to knuckle nut and bolt Quantity: 1.

Torque

Stage 1: 60 Nm

Stage 2: 60°
NOTE: Discard the nuts and bolts.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Integral link nuts and bolts Quantity: 1.

Torque

Stage 1: 40 Nm

Stage 2: 60°
CAUTION: Discard the nut.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Renew Part: Stabilizer bar link nuts Quantity: 1

Torque : 60 Nm
CAUTION:
- Take extra care when handling the assembly. Failure to follow this instruction might result in damage to the CV or the CV boot.
- Discard the bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

3. Using a suitable stand, support the lower arm.

Renew Part: Lower control arm bolt(s) Quantity: 1.

Torque

Stage 1: 110 Nm

Stage 2: 60°
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC