Suspension Air Supply Unit (G2413635): Installation

Install the 2 mounting brackets.
- Install the suspension air supply unit to the vehicle.
- Install and tighten the 4 nuts
  Torque : 10.5 Nm
- Remove the sealing tape from the air line and electrical connector openings.
CAUTION: Do not reuse the air line connector. Always install a new air line connector every time it is released.
- Install a new air line connector.
Refer to: AIR LINE CONNECTOR - SPORTBRAKE

Torque : 3.5 Nm
- Connect the 2 electrical connectors.
- Install the wiring harness to the clip.
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT