| Vehicle air suspension will not raise the vehicle when requested |
Suspension fault message displayed on the IPC (IPC) |
- Expansion chamber air leak
|
- Using the Jaguar Land Rover approved diagnostic equipment, check for air suspension related DTCs and repair as necessary
- Inspect the suspension air supply unit expansion chamber for leaks. If a leak is identified, install a new expansion chamber as required. Refer to: SUSPENSION AIR SUPPLY UNIT (G2413635)
|
| System detects extended mode unnecessarily when lowering |
|
- Crossed gallery and air spring pipes
- Incorrect valve block installed to front or rear
- Damage or blockage in air harness
- Faulty height sensor
|
|
| Vehicle leans/tilts after being left over-night or for some days |
|
- Leaking air spring(s)
- Leak from corner valve to gallery
- Exhaust valve stuck open
|
|
| After vehicle left over-night or for some days system regularly indicates "Suspension vehicle raising slowly" when first driving off |
- Suspension vehicle raising slowly
|
- Leaking air spring(s)
- Leaking reservoir
|
|
| Changes between different rideheights are not smooth |
|
|
|