LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Engine - INGENIUM I4 2.0L Petrol >> Valves >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. G11306860
    1. Apply a small amount of fine grinding paste to the face of the valve.
    2. Install the valve into the cylinder head valve guide.
    3. Using a suitable tool, lap in the valve until a continuous mark is visible on both the valve and the valve seat.
    4. Remove the valve and clean off all the grinding paste from the valve and the valve seat.
  2. Install a new valve stem seal.

    Renew Part: Valve stem oil seals. 

  3. Lubricate the valve stem with clean engine oil.
  4. Install the valve into the cylinder head valve guide.
  5. Install the valve spring and cap.
  6. Using the special tool, install the valve spring retaining collets.
  7. Repeat the installation procedure for the remaining valves.
  8. Install the cylinder head.

    Refer to: Cylinder Head .

  9. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

scientia non olet · About LEMON Manuals