LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Engine - INGENIUM I4 2.0L Petrol >> Specifications

Engine - INGENIUM I4 2.0L Petrol: Specifications

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
LUBRICANTS, FLUIDS, SEALERS AND ADHESIVES

Item SPECIFICATIONS
Sealant Loctite 5970 BM Black
Engine Oil SAE 0W20 STJLR.51.5122
CAPACITIES

Item LITERS
Engine oil, initial fill 7.9
Engine oil, service fill with oil filter change 7.02
Engine oil, service fill without oil filter change 6.47
GENERAL SPECIFICATION

ITEM SPECIFICATION
Type 2.0 litre, inline 4, turbocharged and intercooled petrol engine, twin overhead camshaft, 4 valves per cylinder
Cylinder arrangement Inline 4
Cylinder numbering No. 1 from the accessory drive end
Bore - nominal 83.0 mm (3.270 in)
Stroke 92.29 mm (3.633 in)
Capacity 1997 cm3 (121.9 in3 )
Firing order 1 - 3 - 4 - 2
Spark plug gap 0.7-0.8mm
Direction of rotation Clockwise viewed at FEAD
Compression ratio - Low and Mid spec 10.5:1
Compression ratio - High spec 9.5:1
Cylinder head maximum  permitted warp (flatness specification) 0.2 mm (0.008 in)
Maximum power/torque - Low spec 
Maximum power 147 kW (200 PS) @ 5500rpm
Maximum Torque 320 Nm (236 lb/ft) @ 1300 - 4000rpm
Maximum power/torque - Mid spec 
Maximum power 184 kW (250 PS) @ 5500rpm
Maximum Torque 365 Nm (269 lb/ft) @ 1200 - 4500rpm
Maximum power/torque - High spec 
Maximum power 221 kW (300 PS) @ 5500rpm
Maximum Torque 400 Nm (295 lb/ft) @ 1500 - 4500rpm
Crankshaft end play: 
Minimum 0.15 mm
Maximum 0.35 mm
Main bearing clearance: 
Minimum 0.030 mm
Maximum 0.054 mm
TORQUE SPECIFICATIONS

DESCRIPTION NM LB-FT
Oil pump retaining bolts 25 18
Oil pump chain tensioner retaining bolt 12 9
Oil pump pick-up pipe retaining bolts 12 9
Oil pump chain sprocket retaining bolt:  (1)  - -
Stage 1 60 44
Stage 2 90° 90°
Engine oil drain plug 25 18
Oil filter element cover 27 20
Oil pan retaining bolts 25 18
Transmission to oil pan retaining bolts 48 35
Fuel injection pump retaining bolts 12 9
Lower timing chain idler sprocket retaining bolt 35 26
Lower timing chain guide retaining bolts 25 18
Lower timing chain lever retaining nut 11 8
Lower timing chain tensioner retaining bolts 11 8
Lower timing chain cover retaining bolts (2) - -
Oil cooler retaining bolts:  - -
Stage 1 15 11
Stage 2 25 18
Cylinder head retaining bolts (2) - -
Camshaft cap retaining bolts 11 8
Upper timing chain left side and right side guide retaining bolts 25 18
Upper timing chain top guide retaining bolts 11 8
Upper timing chain tensioner 55 41
Variable camshaft unit retaining bolt:  (1)  - -
Stage 1 10 7
Stage 2 Loosen 1/4 of a turn Loosen 1/4 of a turn
Engine front cover retaining bolts 12 9
Idler pulley retaining bolt 25 18
Coolant pump retaining bolts 12 9
Coolant pump pulley retaining bolts 25 18
Crankshaft pulley bolts:  - -
Stage 1 37 27
Stage 2 90° 90°
Camshaft position (CMP) sensor retaining bolt 8 6
Crankshaft position (CKP) sensor retaining bolt 8 6
Upper timing chain cover retaining bolts (2) - -
Variable camshaft timing solenoid retaining bolts 9 7
Spark plugs 23 17
Ignition coils 8 6
Valve cover retaining bolts (2) - -
oil filter housing retaining bolts 12 9
Cylinder head temperature (CHT) sensor 11 8
Cylinder block temperature sensor 11 8
Manifold absolute pressure (MAP) sensor retaining bolt 5 4
Intake manifold retaining bolts 12 9
Turbocharger to cylinder head retaining nuts 25 18
Turbocharger heatshield retaining bolts 9 7
Turbocharger oil feed pipe unions 18 13
Turbocharger oil drain tube retaining bolt 11 8
High pressure EGR valve retaining bolts 12 9
Throttle body retaining screws 12 9
Oil level gauge tube retaining bolt 8 6
Oil filler neck retaining bolt 12 9
Charge air cooler mounting bracket nuts 12 9
Charge air cooler mounting bracket bolts 47 35
Coolant inlet pipe retaining bolt 8 6
Coolant pipe to cylinder head retaining bolts 12 9
Coolant bypass hose retaining nuts 8 6
Coolant pipe to intake manifold retaining bolts 10 7
Coolant separator retaining bolts 10 7
Engine mount to subframe bolts 47 35
Engine mount to engine bracket nuts 60 44
Engine cover support mounts 6 4
Noise, Vibration and Harshness (NVH) pad retaining nut 8 6
Purge valve front breather pipe retaining bolt 8 6
Engine wiring harness retaining nuts 6 4
Engine wiring harness support bracket retaining bolts 10 7
Transmission oil cooler tubes retaining bolt 12 9
Air Conditioning (A/C) compressor retaining bolts 25 18
AWD models front drive halfsaft support bracket retaining bolts 25 18
Continuous Variable Valve Lift (CVVL) assembly retaining bolts (2) - -
(1) New nuts/bolts must be installed.
(2) Refer to procedure for correct torque sequence.
scientia non olet · About LEMON Manuals