LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Engine - INGENIUM I4 2.0L Petrol >> Oil Pump >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

    General Equipment:  Two-post lift

  2. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Remove the oil pump chain.
  4. G11308715

    Disconnect the oil pump solenoid electrical connector.

  5. G11308716

    Release the oil pump solenoid wiring harness from the 4 retaining clips.

  6. G11308717
    • Remove the 4 bolts securing the oil pump to the engine assembly.
    • Remove the oil pump assembly.
  7. NOTE: Do not disassemble further if the component is removed for access only.
    G11308718
scientia non olet · About LEMON Manuals